English
Español 
Português 
русский 
Français 
日本語 
Deutsch 
tiếng Việt 
Italiano 
Nederlands 
ภาษาไทย 
Polski 
한국어 
Svenska 
magyar 
Malay 
বাংলা ভাষার 
Dansk 
Suomi 
हिन्दी 
Pilipino 
Türkçe 
Gaeilge 
العربية 
Indonesia 
Norsk 
تمل 
český 
ελληνικά 
український 
Javanese 
فارسی 
தமிழ் 
తెలుగు 
नेपाली 
Burmese 
български 
ລາວ 
Latine 
Қазақша 
Euskal 
Azərbaycan 
Slovenský jazyk 
Македонски 
Lietuvos 
Eesti Keel 
Română 
Slovenski 
मराठी 
Srpski језик
How to solve the small fault of industrial and mining dust removal equipment?
2022-12-02
Different faults are solved by different methods
As long as it is a machine, there will be failures. How can we deal with small failures of industrial and mining dedusting equipment?Inability to absorb water or unstable pressure:
1. Check the suction pipe for looseness or air leakage. If air leakage is found, tighten it or replace the suction pipe.
2. Check whether the suction pipe is blocked, and if it is, remove it.
3. Turn on the switch for a while, and then turn it off after letting the remaining gas discharge.
4. Remove the suction chamber to check whether the three suction valves are blocked, and if so, remove them.
5. Check whether the piston valve plug and valve seat are worn. If any, replace them.
Pressure drop:
1. Check whether the triangle belt is loose. If so, adjust it according to the fog gun machine manual.
2. Check whether the spray pipe is broken and the gasket of the spray pipe joint is damaged. If the spray pipe is broken or the gasket of the joint is damaged, replace it.
Key points for attention when connecting industrial and mining dedusting equipment to power and water sources:
1. The industrial and mining dedusting equipment uses the power frequency power supply provided by the generator set (or external mains power supply). The rated working voltage of the motor is AC380V, and the output AC voltage of the generator set is 400V.
2. When three-phase 380V mains power is used, there must be a power switch before connecting to the electric cabinet of industrial and mining dedusting equipment, and the power switch should be well grounded; The power line is connected to the electrical cabinet of the equipment.
3. When connecting the power line, disconnect the power switch in front of the electric control box and place it in the OFF position, and then conduct the wiring operation after confirming that there is no power.
4. The three-phase five wire system is adopted. When selecting the power line, the wire diameter
shall be determined according to the total power specified in the product technical parameters to ensure that the power line has sufficient load capacity.
5. When the water source is connected, a special valve for spray is set. After passing the semi process valve, the pipeline is directly connected to the water inlet of the fog monitor and the water tank outlet.
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies.
Privacy Policy